In the beginning, European crystal chandeliers have been purchased in the past few years!
The European crystal chandelier may be of the last few years It’s likely to need some cleaning up now.
How to clean a chandelier made of crystal is one of them.
The crystal chandelier contains pendants. The crystal ball forms a significant part of the chandelier. How do you clean the crystal ball? This is relatively troublesome!
As a result, if there’s numerous crystal balls on a lamp, it will be more difficult to use.
Before hanging the crystal ball all the crystal must be cleaned and taken apart. Purchases on the internet are needed for the accessories included with the original pendant. Buy it now!
When you have purchased them, it is like it’s a bit more challenging to hang them individually at the time you want to return!
If you purchase a new one, it could be fixed and will be more convenient!
You can do these things provided you have cash.
It’s easy to figure out this puzzle. Remove the cover and rub the crystal onto the ball and you’ll find the solution.
This kind of thing is relatively complicated. It is helpful to send a picture us provide you with an accurate answer.
Crystal chandelier repair
My neighbor’s European crystal chandeliers didn’t light up at all. In actuality, it was a bunch of glass balls. They claimed I bought it for around 1,000 yuan.
I asked if it was able to be fixed, which is why I asked my neighbor to take it apart and take an examination.
The inside is not as stunning as the exterior.
A group of LED lamp beads are connected in series. A switch controls whether the LED light up or the bulb light up or they all light up, and there is an LED driver.
With an adjustable power supply, he tested using an adjustable power supply, he tested the lamp’s LED lampsone by one, and discovered that seven or eight of them failed to light up, so he asked him to pull out the spare lamp beads and replace them (the pins had already been embroidered as a present from the seller and were scratched one at a time to increase the brightness).
I attempted everything and discovered that it wasn’t lit up I removed the switch and examined the whole device, and discovered that there was no sign of burning.
Since it is a switch that is a switch, I decided to skip the experiment first before connecting both circuits to the mains. Both the lightbulb and LED could be illuminated. The switch seems to be the only thing wrong.
The switch appeared like it from the outside.
It’s not like there are any indications of burning inside.
Utilizing tc2608, I looked up for the Datasheet and the typical circuit on the Internet according to the following:
If I test it online, there was no sound. Then I tried the relay without power and applied 12v power. It was found that it could be shut. It appears that the relay isn’t damaged.
Based on the circuit, we know that by bypassing C1 and incorporating 12v DC, we can test the DC situation of the complete circuit. Then we connected power to the bridge and c1 and discovered that the relay can also be closed. It is possible that c1 has been damaged.
Tests online proved that the bridge’s capacity was not correct.
I removed it from the unit and tried to test it offline, but it didn’t work properly either.
The capacitance range is same for both multimeters.
I installed one that I had found in the parts box. It was small, and I wasn’t certain whether it would fit in my.
Connect it to 220v and test it. The relay is able to be removed. The lamp is repaired when the relay is put back.